Publicité
TROUBLESHOOTING
The power does not turn on.
The power cord is not plugged in.
The component that the power cord is plugged into
(amplifier, audio timer, etc.) is not turned on.
No tape is loaded.
The counter display does not move.
The deck is pause mode.
An unrecorded tape is being played.
The heads are dirty. (See "Cleaning tape heads" on
page 10.)
Playback not possible
The amplifier is not set for DAT (TAPE) playback.
The amplifier's volume control is turned all the way
down.
Check for a connection mistake, a loose or discon-
nected cord, poor connection contacts, or a broken
wire.
Connection check.
You are using an erase-protected tape.
General tapes —> Close the erase protection door.
Prerecorded music tapes > Recording is not possible.
The recording (REC) indicator does not light.
Recording not possible
The level meter does not move.
The INPUT selector button is set incorrectly.
The recording level (REC LEVEL) control is turned all
the way down.
The amplifier is not outputting the recording signal
(from the tuner, CD, etc.)
Check for a connection mistake, a loose or discon-
nected cord, poor connection contacts, or a broken
wire.
The deck enters stop mode when PAUSE is released.| 'f "PROH" appears on the display, recording is not
possible. (See p.68)
The counter does not move.
The deck is in pause mode.
ary
The heads are dirty.
|
Clean the heads. (See "Cleaning tape
heads" on page 10.)
92
<RRE1113>
En
Publicité
