Epson EPL-5000 Guide De L'utilisateur page 701

14. Insert the interface cable into the U-shaped part of one cable clip. Lift the left
side of the printer up slightly. Then hook the short lip of the clip into the
forward slot and push the bottom of the clip under the printer until it clicks
in place. Repeat with the second clip and install in the rear slot.
Note:
Hook no more than two cables into one cable clip. Never put too much
pressure on the cables.
15. Be sure the power is turned off and then plug the power cord into an electrical
outlet.
16. Turn on the printer.
Note:
If you did not install the memory module correctly, INSUFF. MEMORY or
ADD MEMORY CH: X shows on the display. Review the steps above to
make sure you correctly installed the SIMM. If the amount of RAM is still
incorrect, contact your dealer or a qualified service person for assistance.
D-14
Option Installation