Before Printing In The Epson Gl/2 Mode; Intelligent Emulation Switch (Ies) - Epson EPL-5000 Guide De L'utilisateur

Before printing in the EPSON GL/2 mode

You may need to change printer settings depending on your output
needs. Always check the printer's settings to make sure they match the
data you are trying to print. Before you switch the emulation mode,
check the following items to avoid conflicts with the printer's settings:
Paper size:
Driver (plotter selection):
If you need to configure the printer settings, switch the emulation;
then change the settings using SelecType or the Remote Control Panel
utility. For information on SelecType, see Chapter 2, for the Remote
Control Panel utility, see Chapter 4.
Caution:
c
Setting or data saved in printer RAM (such as download fonts)
may be erased when you switch emulation.
Note :
The paper automatically ejects if the printer receives no data within
60 seconds.

Intelligent Emulation Switch (IES)

This printer has following IES modes: EpsonScript Level 2/LaserJet
4L, EpsonScript Level 2/LQ, EpsonScript Level 2/FX, EpsonScript
Level 2/GL/2, and LJ4L/LQ. When you select one of the IES settings
with SelecType, the Remote Control Panel utility, or the printer's
control panel, the printer switches automatically between EpsonScript
Level 2 and one of four other modes or between LJ4L mode and LQ
mode, depending on the received data. However the EpsonScript
Level 2 IES settings are available only when the optional EpsonScript
Level 2 module is installed.
Printer's paper size setting
HP-GL/2 or HP-GL plotters
Using Your Printer
1-13