Publicité
Les langues disponibles
Les langues disponibles
Installing the memory module
w
Warning:
High voltages are present inside the printer when the power is on. Do not
attempt to install a SIMM unless the printer is turned off.
1.
Turn off the printer and unplug the power cable from the electrical outlet.
Remove the optional cartridge and lower paper cassette, if installed.
2.
Turn the printer so that its left side is facing you.
3.
Disconnect all interface cables from the interface connectors.
4.
Remove the two screws securing the interface card cover; then pull off the
cover. Keep the screws handy so that you can use them later.
c
Caution:
Before you remove the controller board, make sure that you remove any
optional cartridges. Otherwise, you may damage it.
Option Installation
D-9
Publicité
Chapitres
Dépannage
