Publicité
INSTRUCTIONS FOR USE
3.2.12
Rotate the Support Top 180°
WARNING:
Before you adjust the Allen Advance Table or use the flip or tilt features, make
sure that the brakes are locked, the patient is secured against the prone support
set, the patient is fully prepared for the adjustment; the Allen Advance Table is
free of objects that could interfere with the adjustment, and all loose or
unsupported objects have been secured. Otherwise, patient fall, injury, or
equipment damage could occur.
1.
Make sure that—
• The brakes are locked (the locked indicator on the
Allen Advance Table display is green).
• The patient is secured to the support top and is fully
prepared for the adjustment.
• The Allen Advance Table is in the correct position for you to install a second
support top:
– The columns are at the same height.
– The Allen Advance Table and the installed support top are level. See "Level
the Allen Advance Table and the Support Top" on page 42.
– The Allen Advance Table is free of objects that could interfere with the
adjustment.
– All loose or unsupported objects have been secured.
• The Rail Top has the Prone Supports installed. If it does not, install them (see
page 35).
2.
Install the second support top as follows:
a. At one end of the Allen Advance Table, put the upper
H-bracket in position on the bowtie. Hold the H-
bracket so that the open end is down, the J ends are
toward you, and the H-bracket is angled toward you.
b. Install the J ends of the H-bracket on the bowtie so
that the H-bracket fits into the notches on the sides of
the bowtie.
Document Number: 80028190
Version: E
Page 43
English
Issue Date: 16 MAY 2022
Ref Blank Template: 80025117 Ver. F
Publicité
