Publicité
INSTRUCTIONS FOR USE
WARNING:
Do not use the support top without the cross pins installed correctly through the
H-brackets. To do so could cause patient fall, injury, or equipment damage.
i.
Make sure that—
• All cross pins are correctly installed into the H-brackets and support tops.
• The drop lock on the end of the cross pins has moved to the side to hold the
support tops and H-brackets in position.
3.
Loosely install a minimum of four safety straps evenly spaced and around both
support tops.
NOTE: We recommend that you use the four Allen® Safety Straps that were included with
the support top.
4.
Make sure the support tops are in the correct position, and then tighten the safety
straps.
5.
Make sure the superior support top is progressively compressed against the patient
and once again tighten the safety straps.
6.
Look at the display, and make sure the tilt level indicator
and the brakes locked indicator are green.
WARNING:
We recommend that a minimum of four caregivers
are available to help flip the patient. However, the
number of caregivers will vary based on the patient
weight and should be determined by the facility staff
for each flip procedure. Failure to do so could cause
patient fall, injury, or equipment damage.
WARNING:
Observe lines closely during articulations. Always use good line management
techniques. Failure to do so could cause patient fall, injury, or equipment
damage.
WARNING:
Failure to observe the patient's head while the support top is being flipped could
cause patient fall or injury.
Document Number: 80028190
Version: E
Page 45
English
Issue Date: 16 MAY 2022
Ref Blank Template: 80025117 Ver. F
Publicité
