Publicité
INSTRUCTIONS FOR USE
5.
With the help of another person, do as follows:
a. Align the ends of the support top with the pre-determined hole location. If you
are to install a Flat Top without a pad installed, make sure the side with the
Velcro® tape is up (patient side).
NOTE: You may have to adjust the length of the Allen Advance Table so that the columns
are at the correct distance apart to fit the support top "Adjust the Length of the Allen
Advance Table" on page 31.
WARNING:
Never remove a cross pin from a support top while a patient is on the support top.
Patient fall or injury could occur.
b. At each end of the support top, insert a cross pin into
the H-bracket, through the support top connector
assembly, and through the other end of the H-
bracket.
WARNING:
Do not use the support top without the cross pins installed correctly through the
H-brackets. To do so could cause patient fall, injury, or equipment damage.
c. Make sure the drop lock on the end of the cross pin moves to the side to hold the
support top in position.
Remove a Support Top and/or Bracket
WARNING:
Never remove a cross pin from a support top while a patient is on the support top.
Patient fall or injury could occur.
1.
Make sure the patient has been moved from the support top.
2.
Do the applicable steps of the install procedure in reverse order.
NOTE: To remove a cross pin, align the drop lock with the pin, and hold the lock in as you
remove the cross pin from the H-bracket.
Document Number: 80028190
Version: E
Page 34
English
Issue Date: 16 MAY 2022
Ref Blank Template: 80025117 Ver. F
Publicité
