Publicité
INSTRUCTIONS FOR USE
When the brakes are locked, the locked indicator on the
display is green; when the brakes are not locked, the
unlocked indicator is orange.
During a loss of power, if the brakes are locked and it is
necessary to move the Allen Advance Table, use the
Emergency Brake Release on both columns to manually
unlock the brakes.
Manually Release the Brakes
Pull the Emergency Brake Release on both columns.
NOTE: Each column has a release. You must pull both releases
to unlock the brakes. The handles do not have to be pulled at
the same time.
Reset the Electronic Brakes after being Manually Released
After you use the Emergency Brake Releases to unlock the brakes, you must do these
steps to lock or reset the brakes:
1.
Make sure there is power to the Allen Advance Table, and
its On/Off switch is on.
2.
Press and hold the Key control as you press the Unlock
control. You will hear the brakes move.
3.
Press and hold the lock control until the locked indicator
on the Allen Advance Table display is green.
4.
Try to move the Allen Advance Table to make sure the brakes are locked. If the
brakes did not lock, repeat Step 2 and Step 3.
Document Number: 80028190
Version: E
Page 30
English
Issue Date: 16 MAY 2022
Ref Blank Template: 80025117 Ver. F
Publicité
