Publicité
INSTRUCTIONS FOR USE
NOTE: The flip indicator on the display turns off to show that the support tops are locked
in position. The pendant indicator on the display turns green to show that you can use the
pendant controls.
10. Make sure the support tops are locked in position. If the tops did not lock, repeat
Step 9.
11. Remove the straps from around the support tops.
WARNING:
Failure to use correct lifting methods could cause patient fall, injury, or equipment
damage.
12. With the help of another person, carefully remove the upper support top.
13. Carefully remove the upper H-brackets.
14. Make sure the patient is in the correct position for the surgical procedure.
3.2.13
Transfer a Patient
WARNING:
Before you transfer the patient, make sure the brakes on the Allen Advance Table
and the other transfer device are locked and the patient and staff are fully
prepared for the movement. Otherwise, patient fall, injury, or equipment
damage could occur.
1.
Make sure of these:
• The brakes on the Allen Advance Table and the
other transfer device are locked. (The locked
indicator on the Allen Advance Table display is
green.)
• The Allen Advance Table is in pendant control
mode. (The pendant control indicator on the Allen
Advance Table display is green.)
• The patient and staff are fully prepared for the
transfer.
2.
Make sure the Allen Advance Table support top and the
surface of the transfer device are at the same height.
Document Number: 80028190
Version: E
Page 47
English
Issue Date: 16 MAY 2022
Ref Blank Template: 80025117 Ver. F
Publicité
