Display; The Buttons - Unold 68425 Notice D'utilisation

DISPLAY

BASIC SETTING:
Appears as soon as the appliance is plugged into the elec-
trical outlet. In the display, the information for program
1 (Basic) and the medium degree of browning are shown.
During operation, the program status is indicated both by
the time countdown and the symbols on the display.
The following messages on the display indicate an error:
HHH or LLL: This message indicates a defect in the tem-
perature sensor. Please have the appliance inspected by
our service department.

THE BUTTONS

On/Off-Switch
To switch the appliance on or off. This switch is located
at the lower side of the back of the housing. If you don't
use the appliance, you should always switch it off in order
to interrupt the power supply and then take the plug out
of the receptacle. The programs can only be selected and
started when the appliance has been switched on.
START/STOP button
This button is used to start and stop the program. With the
START/STOP button you can cancel the program at any
time. For safety reasons, this button responds with a slight
delay; therefore, keep the button pressed until you hear a
signal tone. The start position of the Basic program appears
in the display. If you want to use a different program, select
the appropriate program with the Menu button.
MENU
The Menu button is used to select the individual programs,
which are described in detail in the „Program Sequence"
table. The number corresponding to the program appears
on the display to indicate the selected program. Use the
programs as described below:
Programm- Programm-
nummer name
1 BASIS
BASIC
2 WEISS-
BROT
WHITE
BREAD
3 VOLLKORN
WHOLE
GRAIN
4 SCHNELL
FAST
40
Verwendung
The standard program for all
breads, such as white breads
and multi-grain breads
For especially light white
breads with longer rising
times
For whole-grain breads
For faster baking of white
and multi-grain breads
Copyright UNOLD AG | www.unold.de
E E0 and E E1:
If this appears after pressing the START/STOP button the
appliance is still too hot from the last baking cycle. Open
the lid and allow the appliance to cool for another 10 to
20 minutes.
Programm- Programm-
nummer name
5 HEFE-
TEIG
YEAST
DOUGH
6 ULTRA-
SCHNELL I
ULTRA-FAST
I
7 ULTRA-
SCHNELL II
ULTRA-FAST
II
8 TEIG
DOUGH
9 KONFITÜRE
JAM
10 BACK-
PULVER
BAKING
POWDER
11 TOASTBRO
TOAST
12 BACKEN
BAKE
13 EIGEN-
PROGRAMM
USER
PROGRAM
Verwendung
For preparing sweet yeast
dough
For all level I recipes that are
baked in the programs Basic,
White Bread, Toast bread or
Fast. The dough rises for a
significantly shorter period
of time in the Ultra-Fast pro-
gram and consequently the
breads are more compact
and not as loose. A time pre-
select is not possible. Use
lukewarm liquids with this
program.
For all level II recipes that
are baked in the programs
Basic, White Bread, Fast or
Toast Bread See Ultra fast I.
For preparing dough, without
bake function
For cooking jams and jel-
lies. For for making jam, you
should purchase a second
baking pan which is used
only for this purpose.
For baked goods baked with
baking powder, such as bat-
ter cakes
For preparing bread
toasting
For baking of yeast or batter
dough that has been prepared
separately (either by hand
or in the DOUGH program).
This program is not suitable
for pie dough or choux pastry
dough, etc.
Individual adjustment of the
program phases
for