Textron RANSOMES Commander 3510 Manuel page 8

GB
While mowing, always wear substantial footwear and
long trousers. Do not operate the equipment when
barefoot or wearing open sandals.
Check the grass catcher frequently for wear or
deterioration. After striking a foreign object. Inspect.
the lawnmower for damage and make repairs before
restarting and operating the equipment.
If the machine starts to vibrate abnormally, check
immediately.
IMPORTANT: The machine must always be used
in 4 wheel drive for cutting.
TRANSPORTING
Ensure that the cutting units are securely fastened in
the transport position. Do not transport with cutting
mechanism rotating.
Drive the machine with due consideration of road and
surface conditions, inclines and local undulations.
Sudden decelerating or braking can cause the rear
wheels to lift.
Remember that the stability of the rear of the
machine is reduced as the fuel is used.
IMPORTANT: Transport speed is for highway use
only. Never select transport speed or two wheel
drive on grass areas or uneven or unsurfaced
roads or tracks.
LEAVING THE DRIVING POSITION
Park the machine on level ground. Before leaving the
driving position, stop the engine and make sure all
moving parts are stationary. Apply brakes and
disengage all drives. Remove the starter key.
SLOPES
TAKE EXTRA CARE WHEN WORKING ON
SLOPES
Local undulations and sinkage will change the general
slope. Avoid ground conditions which can cause the
machine to slide. Keep machine speeds low on
slopes and during tight turns.
Sudden decelerating or braking can cause the rear
wheels to lift. Remember there is no such thing as a
"safe" slope. Travel on grass slopes requires
particular care.
DO NOT USE ON SLOPES GREATER THAN 15°
The slope 15° was calculated using static
stability measurements according to the
requirements of EN 836.
IMPORTANT: When working on any slope set the
weight transfer to its maximum (+) setting.
GB-NL-F-6