Shipping The Unit / Draining The Reservoir - SciCan AUTOCLAVE Statim 2000 G4 Manuel De L'utilisateur

8 Maintaining your STATIM
8.11 Shipping the Unit / Draining the Reservoir
Before you move the unit, you will need to drain the reservoir. To do so, follow these steps:
1.
Place a water container below the unit.
2.
Using the drain tube (see Section 3.5 Priming the Pump, Figure 6) empty the contents of
the reservoir into the water container.
3.
Remove any remaining water from the reservoir with a non-linting, absorbent towel.
4.
Screw-in the three leveler feet found underneath the unit.
5.
Repack the unit in the original packing materials and include all accessories originally
included with the unit.
6.
Specify heated and insured shipping.
Page 39