Setting Up Your Statim; Positioning And Powering Your Unit - SciCan AUTOCLAVE Statim 2000 G4 Manuel De L'utilisateur

3 Setting up your STATIM
3.1 Positioning and Powering your Unit
Positioning your Unit
There are several factors that may affect the performance of your STATIM. Please review
these factors, and select a suitable location in which to install the unit.
•
Temperature and Humidity
Avoid installing your STATIM in direct sunlight or close to a heat source (e.g. vents or
radiators). The recommended operating temperatures are 15-25˚C with humidity of 25-70%.
•
Spacing
The vents and openings on your STATIM should remain uncovered and unobstructed.
Leave a minimum of 50 mm between the top, sides and back of the unit and any wall
or partition. For more detailed information on clearances, see Specifications.
•
Venting
Your STATIM should be operated in a clean, dust free environment.
•
Work Surface
Your STATIM should be placed on a flat, level, water-resistant surface.
Never install and operate the unit on a sloped surface.
•
Electromagnetic Environment
Your STATIM has been tested and meets applicable standards for electromagnetic
emissions. While your unit does not emit any radiation, it may itself be affected by other
equipment which does. We recommend that your unit be kept away from potential sources
of interference.
•
Electrical Connection
To power your unit, use properly grounded and fused power sources with the same voltage
rating as indicated on the label at the back of your STATIM. Avoid multiple outlet receptacles.
If using a surge suppressor power bar, connect only one STATIM to it.
Powering your Unit
To power your STATIM, connect the power cord to the A.C. inlet receptacle at the back of
the unit. Ensure the power switch is in the OFF position and connect the unit to your
power source.
Page 11