Using Cassettes And Preparing Instruments; Using The Statim 2000 G4 Cassette - SciCan AUTOCLAVE Statim 2000 G4 Manuel De L'utilisateur

4 Using Cassettes and Preparing Instruments
4.1 Using the STATIM 2000 G4 Cassette
When removing the cassette after a cycle, exercise caution as the metal areas will be hot
and the cassette may contain hot steam.
Opening the Cassette:
1. Hold the cassette handle with your thumbs facing
inward on the cassette latch.
2. Push downward on the cassette latch.
3. Raise the cassette lid upwards and disengage
the hinge.
4. Rest the lid on its outer surface.
Closing the Cassette:
1. Align the hinge tab on the cassette lid with
the hinge slot on the rear of the bottom tray.
2. As you begin to close the lid, the hinge tab and slot will engage.
Inserting the Cassette into the STATIM G4 2000:
1. Place the end of the cassette into the unit.
2. Gently push inward until you hear a "click" sound and check the LCD icon for change
from to .
Never force the cassette into the STATIM as the interior components could be damaged.
NOTE: The main menu screen will display if the cassette is not properly inserted
in the unit.
Removing the Cassette:
1. Grasp the handle with two hands and pull away from the unit.
2. Pull the cassette clear of the unit and set down on a firm surface.
Disengaging the Cassette:
When not in use, the cassette should be disengaged. To disengage the cassette, grasp
the handle and pull the cassette out until there is a 15 mm to 20 mm (
between the front of the STATIM and the cassette handle.
Using the STAT-DRI Drying Agent
Treatment of the interior surfaces of the cassette with the STAT-DRI drying agent, provided
with your unit, will enhance the drying process. (Replacement bottles are available from
SciCan, order number 2OZPLUS, 8OZPLUST, 32OZPLUS).
Figure 7
Page 19
cassette latch
1 3
/ to / ") gap
2 4