Using The Statim 5000 G4 Cassette - SciCan AUTOCLAVE Statim 2000 G4 Manuel De L'utilisateur

4 Using Cassettes and Preparing Instruments
4.2 Using the STATIM 5000 G4 Cassette
When removing the cassette after a cycle, exercise caution as the metal areas will be hot
and the cassette may contain hot steam.
Opening the Cassette:
1. Push the carry handle into the
open position.
2. Put your hands on either side
of the cassette handle .
3. Insert your forefingers in the slots and
place your thumbs on the thumb pads.
4. Press down with your thumbs and
pull up with your forefingers until
the lid opens.
5. Raise the cassette lid and disengage
from the tray. Rest the lid on its
outer surface.
Closing the Cassette:
1. Align the hinge tab on the lid with the
hinge slot on the tray.
2. As you begin to close the lid, the hinge
tab and slot will engage.
3. Place the carry handle into
the closed position.
Inserting the Cassette into the
STATIM 5000 G4:
1. Hold the cassette handle in one hand
and the carry handle in the other
as shown in Figure 8.
2. Place the end of the cassette into the unit and drop the carry handle
into its closed position.
3. Gently push inward until you hear a "click" sound and check the LCD icon for change
from to .
Never force the cassette into the STATIM as the interior components could be damaged.
NOTE: The main menu screen will display if the cassette is not properly inserted
in the unit.
2
2
1
2
Figure 8
Page 20
1
2