Assigning The Unit Identifier Number; Creating A User Id And Pin; Setting Up Process Enforced Usage - SciCan AUTOCLAVE Statim 2000 G4 Manuel De L'utilisateur

3 Setting up your STATIM
3.9 Assigning Unit Identifier Number
1.
2. Scroll to and select.
3.
Using the keypad, select a maximum of 3 digits to be used as the unit's identifier number.
Press to save and to return to the Setup menu.
3.10 Creating a User ID and PIN
1.
2. Scroll to and select.
3.
From the SETUP PIN screen, you can assign up to four PINs. Select one of
the User icons to assign a PIN.
4.
Using the keypad, assign a PIN of up to four digits and press to save and
to move to the confirmation screen.
Setup PIN
º
5.
If all of the information presented in the confirmation screen is correct, press OK
to be returned to the PIN USER screen. To make a correction, select the PIN User you
want to change and repeat the process described above.
3.11 Setting Up Process Enforced Usage
When process enforced usage is activated, users are required to enter a PIN both at the
beginning and at the end of a cycle. For Process Enforced usage to function, User IDs and
PINs must first be assigned. To set up User ID and PINs, refer to section 3.10 Creating a
User ID and PIN. To activate process enforced usage, follow these steps:
1.
2. Scroll to and select.
3.
Use to toggle Process Enforced function ON or OFF. Press
to save your selection and return to the Setup menu.
NOTE: Any user can stop a cycle and remove the cassette even with Process Enforced
usage ON. However, the cycle data will record that an unauthorized user has stopped
the cycle and/or removed the cassette.
Unit No
EN
User
Process Enforced
PIN Setup
0000
1 2 3
4 5 6
7 8 9
CL 0 EN
Page 16
User x
PIN Updated
New PIN xxxx
OK