Error Messages - ero electronic MKS Manuel De Service

F.CAL see "Feedback potentiometer calibration".
POS.L see "Feedback potentiometer calibration"
Fb.LC see "Feedback potentiometer calibration"
POS.H see "Feedback potentiometer calibration"
Fb.HC see "Feedback potentiometer calibration"
XKSser1-B0.PMD 23
ERROR ERROR ERROR ERROR ERROR MESSAGES MESSAGES MESSAGES MESSAGES MESSAGES
OVERRANGE, UNDERRANGE AND SENSOR OVERRANGE, UNDERRANGE AND SENSOR OVERRANGE, UNDERRANGE AND SENSOR OVERRANGE, UNDERRANGE AND SENSOR OVERRANGE, UNDERRANGE AND SENSOR
LEADS BREAK INDICATIONS LEADS BREAK INDICATIONS
LEADS BREAK INDICATIONS LEADS BREAK INDICATIONS LEADS BREAK INDICATIONS
The device is capable to detect a fault on the process variable
(OVERRANGE or UNDERRANGE or SENSOR LEADS
BREAK).
When the process variable exceeds the span limits
established by configuration parameter P 1 an
OVERRANGE condition will be shown on display as
shown in the following figure:
An UNDERRANGE condition will be shown on display as
shown in the following figure:
When P41 is different from zero and an out of range
condition is detected, the instrument operates in
accordance with P41 and P42 parameters.
When P41 is equal to 0 (standard effect) and time
proportional outputs are configured, the following
conditions may occur:
- The instrument is set for one output only and an
OVERRANGE is detected, the OUT 1 turns OFF (if
reverse action) or ON (if direct action).
- The instrument is set for heating/cooling action and an
OVERRANGE is detected, OUT 1 turns OFF and OUT 3
turns ON.
- The instrument is set for one output only and an
UNDERRANGE is detected, the OUT 1 turns ON (if
reverse action) or OFF (if direct action).
- The instrument is set for heating/cooling action and an
UNDERRANGE is detected, OUT 1 turns ON and OUT
3 turns OFF.
GB GB
GB GB GB 23
12/09/2005, 9.46