Preliminary Hardware Settings; Input Selection - ero electronic MKS Manuel De Service

PRELIMINARY HARDWARE SETTINGS

PRELIMINARY HARDWARE SETTINGS PRELIMINARY HARDWARE SETTINGS PRELIMINARY HARDWARE SETTINGS PRELIMINARY HARDWARE SETTINGS
How to remove the instrument from its case How to remove the instrument from its case How to remove the instrument from its case
How to remove the instrument from its case How to remove the instrument from its case
1) Switch off the instrument.
2) Push gently the lock A on the right.
A
3 ) While the lock A is maintained out, slide out the right
side of the instrument.
A
4) Push gently the lock B on the left.
5 ) While the lock B is maintained out, slide out the
instrument.
B
XKSser1-B0.PMD 6

INPUT SELECTION

INPUT SELECTION INPUT SELECTION INPUT SELECTION INPUT SELECTION
1) Remove the instrument from its case.
2) It is necessary to set J1 according to the desired input type
as shown in the following figure.
INPUT J1
TYPE 1-2 3-4 5-6
TC-RTD open close open
60 mV open close open
5 V close open close
10 V open open close
20 mA open open open
NOTE NOTE NOTE NOTE NOTE : the not used jumper can be positioned on pin 7-9
2 4 6 8 10
J1
1 3 5 7 9
GB GB GB GB GB 6
12/09/2005, 9.46
7-8 9-10
open open
open open
open open
open open
close close
Fig. 11