Ryobi RCS-3535C2 Manuel D'utilisation page 39

GB
F D E I
Problem
Engine starts, runs, and
accelerates but will not idle.
Chain turns at idle.
Bar and chain running hot
and smoking.
Engine starts and runs, but
chain is not rotating.
P NL S DK N FIN GR HU
TROUBLESHOOTING
Possible Cause
C a r b u r e t o r r e q u i r e s
adjustment to idle speed.
C a r b u r e t o r r e q u i r e s
adjustment to idle speed.
A i r l e a k i n t h e i n t a k e
system.
Chain oil tank empty.
Chain tension is too tight.
Oiler is not functioning.
Clogged oil passages.
Chain brake is engaged.
Chain tension is too tight.
G u i d e b a r a n d c h a i n
assembled incorrectly.
Guide bar and/or chain are
damaged.
D r i v e s p r o c k e t t e e t h
damaged
CZ RU RO PL SLO HR TR EST LT
English
Turn idle speed screw "T" clockwise to increase idle
speed. Refer to Adjusting the Carburetor in the
Maintenance section of this manual.
Turn idle speed screw "T" counterclockwise to decrease
speed. Refer to Adjusting the Carburetor in the
Maintenance section of this manual.
Contact an authorized service center for a rebuild kit.
Oil tank should be fi lled every time fuel tank is fi lled.
Tension chain per instructions in Adjusting the Chain
Tension in the Maintenance section of this manual.
Run at half throttle 30 to 45 seconds. Stop saw and check
for oil dripping from guide bar. If oil is present, the chain
may be dull or bar may be damaged.
Remove the clutch cover and guide bar plate and clean
oil passages with a stiff-bristle brush.
Release chain brake. Refer to Operating the Chain
Brake in the Operation section of this manual.
Tension chain per instructions in Adjusting the Chain
Tension in the Maintenance section of this manual.
Refer to Replacing the Guide Bar and Chain in the
Maintenance section of this manual
Inspect guide bar and chain for damage.
Contact an authorized service center for drive sprocket
replacement.
36
LV
Solution
SK BG