Disassembly/Exchange - Aventics HF03 LG Mode D'emploi

78 AVENTICS | EtherCAT | R412012792–BDL–001–AB

Disassembly/exchange

Risk of uncontrolled actuator movements when the
pneumatics are switched on
Danger of injury if the system is in an undefined state
and the manual overrides are set to position "1".
O Put the system in a defined state before switching it
on.
O Set all manual overrides to position "0".
O Make sure that no personnel are within the
hazardous zone when the compressed air supply is
switched on.
O Also observe the applicable instructions and safety
information in the VS operating instructions.
1. Switch on the operating voltage.
2. Check the LED displays on all modules.
3. Switch on the compressed air supply.
8 Disassembly/exchange
You can exchange the bus coupler, if needed.
The AVENTICS warranty only applies to the delivered
configuration and extensions taken into account in
the configuration. The warranty no longer applies
after a conversion that exceeds these extensions.
CAUTION