Description Of Device; Preparing For Commissioning - ATIKA BS 205 Notice Originale

Long and thin connection lines result in a potential drop.
The motor does not reach any longer its maximal power; the
function of the device is reduced.
Protect yourself against an electric shock. Avoid touching
earthed parts with your body.
Do not use the cable for purposes for which it is not meant.
Protect the cable against heat, oil and sharp edges. Do
not use the cable to pull the plug from the socket.
Regularly check the saw cable and if damaged, have it
renewed by a recognised skilled electrician.
When running the connection line observe that it does not
interfere, is not squeezed, bended and the plug connection
does not get wet.
Regularly check the extension cables and replace them if
they are damaged.
Do not use any defective connection cables.
When working outdoors, only use extension cables espe-
cially approved and appropriately labelled for outdoor use.
Do not set up any provisional electrical connections.
Never bypass protective devices or deactivate them.
Only hook up the machine by means of a fault-current circuit
breaker (30 mA).
The electrical connection or repairs to electrical parts of
the machine must be carried out by a certified electrician
or one of our customer service points. Local regulations –
especially regarding protective measures – must be ob-
served.
Repairs to other parts of the machine must be carried out
by the manufacturer or one of his customer service
points.
Use only original spare parts and accessorie parts. Acci-
dents can arise for the user through the use of other
spare parts. The manufacturer is not liable for any dam-
age or injury resulting from such action.

Description of device

1 Adjusting wheel for
clamping of saw
band
2 Upper case door
3 Pushing stick holder
4 Pushing stick
5 Circuit closer/breaker
6 Lower case door
7 Lower band saw roll
8 Saw table
9 Table insert
10 Parallel stopper
11 Saw band
12 Saw band coping
13 Upper band saw roll
14 Adjusting wheel for
saw coping
15 Transverse adjust-
ment saw table
16 Splinters suction
socket
17 Base
18 Line cord
19 Motor
20 Adjusting wheel for
upper band saw roll

Preparing for commissioning

To obtain a perfect working of the machine follow the
following advices:
Place the saw in a place that fulfils the following conditions:
− secured against slipping
− free of vibrations
− even
− free of tripping hazards
− adequate light
For a safe standing position the saw must be tightened on a
stable ground (i.e. work bench or underframe) on optimal
working height:
− Provide ground with 4 bore holes
Before each use, check
− Connection cables for defects (cracks, cuts, etc.)
Do not use any defective cables.
− the table insert for its proper condition
− the saw band for its faultless condition
− that all doors are closed
− whether the pushstick is to hand
Do not use any deformed or damaged saw bands.
Replace a worn-out or damaged table insert immediately.
When the machine is not used open-air it must be con-
nected on both suction sockets with a splinter extraction
system (i.e. portable small dust extractor).
27