Safety Instructions; Description Of Device / Spare Parts; Preparing For Commissioning - ATIKA KGSZ 305 N-2 Notice Originale

Safety instructions

Read all safety warnings and all instruc-
tions. Failure to follow the warnings and instructions may result
in electric shock, fire and/or serious injury.

For safety instructions, please refer to the enclosed bro-
chure "Safety instructions for crosscut and mitre saws".

Description of device / spare parts

 Please refer to the attached assembly and operating instruc-
tion sheet.
Pos. Order-no. Designation:
1 366449 Handle with On/Off switch
1A 366451 On/Off switch
1B  Laser switch
1C 366452
Switch lock
2  Carrying handle
3  Motor
4  Carbon brush cover
5  Transport locking pin
6 363543 Set screw for the pulling device
7  Locking screw for rotary table
7A  Rotary table locking
8  Rotary table
9 366445 Table insert
10  Scale for mitre angle
11 366442 Work piece stop
11A 366443 Auxiliary stop
11B 366444 Locking screw for auxiliary stop
12 
Set screw for work piece stop
13 366450 Laser head
13A Battery compartment
14  Locking screw for the laser
15  Protective cover
16 366446 Pendulum cover
16A  Holder for the pendulum cover
17  Lock for pendulum cover
18 363572 Support arm
19 Vice assembly
20 363536 Star grip nut for vice assembly
21 Star grip
22  Dust bag
23  Exhaust neck
24 366447 Incline angle locking handle
25 
Scale for incline angle
26 
Indicator for incline angle
27 
Set screw for 90° saw head position
28 
Locking nut for set screw (90°)
29  Set screw for 45° saw head position
30  Locking nut for set screw (45°)
31 
Set screw for the saw blade position
32  Locking nut for set screw (saw blade
position)
15
33  Adjusting screw for groove depth
34  Stop for adjusting screw
(groove depth)
35  Hexagonal screw for saw blade mounting
36 
Front saw blade flange
37 366448
Saw blade ( 305x30x3.0x60T)
38 
Rear saw blade flange
39  Saw blade locking device
40  Mounting holes
41 
Carbon brush

42 Installation wrench
43 363623 Warning label 1
44 366062 Warning label 2
45 366453 Data / Safety label

Preparing for commissioning

 To achieve flawless functioning of the machine, please
follow the instructions listed:
 Place the machine at a location that meets the following
conditions:
 secured against slipping
 free of vibrations
 even
 free of tripping hazards
 adequate light
 Before each use, check
 Connection cables for defects (cracks, cuts, etc.).
Do not use any defect cables
 the table insert for proper condition
 the saw blade for flawless condition
 Do not use deformed or damaged saw blades.
 Immediately replace a worn or damaged table insert.
 Connect the machine to a dust collection device when saw-
ing wood.
 To ensure a safe position of the saw it must be bolted down
on a solid surface (e.g. workbench or support frame) at opti-
mal working height:
Mounting on a workbench / work table:
Place the device on a level flat workbench or work table.

An uneven surface may result in saw blade jamming
or inaccurate cutting.
Make 4 holes in the workbench / work table matching the
holes in the base plate (40).
Bolt the device down.
Removing the transport locking pin
Remove the transport locking pin before use:
Slightly push the handle (1) down
Pull out the transport locking pin (5).