Transport; Storage; Guarantee; Possible Faults - ATIKA KGSZ 305 N-2 Notice Originale

Replacing the table insert
Immediately replace a worn or damaged table insert.
Loosen the screws of the table insert (9) and remove them.
Insert a new table insert and screw it tightly in place.

Transport

Remove mains plug before each transport.
Before each transport

Position saw head vertically

Turn rotary table to 0°

Push saw head down and engage the transport locking

pin (5)
Remove the support arms (18) and the vise assembly

(19)
Secure the pulling device.

Carry the saw on its transport handle (2).

Always carry the saw on the carrying handle (2) or on
the outer cast parts. Do not hold the saw on the pro-
tective covers or handle (1) when lifting it.

Possible faults

Before each fault elimination:
 Switch off device.
 Wait for standstill of the saw blade
 Pull out power plug

After each fault clearance, put into operation and recheck all security installations.
Fault code
Machine does not start after
switching on
No crosscut function
Machine stops while cutting  Saw blade is dull
Saw blade jams while cut-
ting
Burned spots at the cut
areas
Saw vibrates
Chip outlet is clogged
Rotary table moves hard
Possible Cause
 Power failure
 Extension cable defective.
 Motor or switch defect
 Transport locking pin not removed
 Locking device for pendulum cover
not opened
 Feed is too great
 Saw blade is dull
 Saw blade is not suitable for the
work step or is dull
 Saw blade is warped
 Saw blade not properly mounted
 No exhaust system connected
 Exhaust power too weak
 Chips under rotary table

Storage

Pull out power plug
 Store unused equipment in a dry, locked place out of the
reach of children.
 Before extended storage, please observe the following to
increase the service life of the device and to ensure smooth
operation:
 Thoroughly clean the device.
 treat all movable parts with an environmentally friendly oil

Never use any grease!

Guarantee

Please observe the enclosed terms of guarantee.
Remedy
 Check the fuse.
 Check cables, do not go on using defect cables
 Have motor or switch checked by an approved electrician
or replaced by original spare parts
 Pull out transport locking pin (5)
 Open locking device (17)
 Replace saw blade (37)
 Allow motor to cool and proceed working with less pres-
sure
 Hold the work piece firmly and cut off the motor immediate-
ly. Replace then the saw blade.
 Replace saw blade
 Replace saw blade
 Mount saw blade properly
 Switch off saw, remove chips and connect exhaust system
 Switch off saw, remove chips and increase exhaust power
(air velocity ≥ 20 m/sec at chip exhaust neck.
 Remove chips
20