Commissioning; Dust/Chip Exhaustion - ATIKA KGSZ 305 N-2 Notice Originale

Inserting the batteries
Open the battery compartment (13A)
Insert two batteries of the type Micro LR03 (AAA, not in-
cluded) and observe the specified polarity.
Close the battery compartment again (13A).

Commissioning

Mains connection
Compare the voltage listed on the device type plate, e.g. 230 V,
with the mains voltage and connect the device to the corre-
sponding and proper socket.
Connect the machine via a 30 mA fault-current circuit breaker.
Use the connection or extension cable according to IEC 60 245
(H 07 RN-F) with a core cross-profile section of at least
 1.5 mm² for cable lengths up to 25 m
 2,5 mm² bei Kabellänge über 25 m
On/Off switch
Do not use any device where the switch can not be
switched on and off. Damaged switches must be repaired or
replaced immediately by the customer service.
Switching on:
Press the switch lock (1C) and then the ON/OFF switch
(1A).
You can let go of the switch lock (1C) during the cutting
process.
Switching off
Release the On/Off switch again.
Switching on the laser
Press the On/Off switch for the laser (1B).
Only switch on the laser when a work piece is on the
rotary table.

Dust/chip exhaustion

The wood dust generated during operation impedes
the necessary view and is harmful to health to some
degree.
Unless the machine is used outdoors, the dust bag or a chip
exhaust system (e.g. portable dust remover) must be connected.
Make sure that the connections for the dust extraction
and the dust bag (collecting device) are connected and
used correctly.
Dust bag

When using the dust bag:
push the dust bag (22) onto the exhaust neck (23).
empty the dust bag regularly
Chip exhaustion
Connect a chip exhauster or a small vacuum to the chip
exhaust neck (23) (Ø 40 mm) using a suited adapter.

Air velocity at the exhaust neck of the saw
≥ 20 m/sec
Use a special exhaust device when exhausting dusts
that are especially harmful to health, carcinogen or
dry.
Attaching table extension
Handling long work pieces with the help of the sup-
plied support arms.
The support arms can be mounted to the left and right of
the machine.
Insert the support arms (19) into the respective holes on
the sides.

Safely support long work pieces with suitable means. For
example, use saw horses or similar devices to support
overhanging work pieces.
Vice assembly
Always secure work pieces to be handled. Do not cut
work pieces that cannot be secured with the vice as-
sembly.
The vice assembly can be positioned to the left or right of
the saw head.
Insert the vice assembly (19) at the right or left into the
hole provided.
Secure it using the machine knob (20).
Press the work piece firmly against the work piece stop
(11).
To fix the work piece turn the machine knob (21) of the
work piece clamping device clockwisely.
Auxiliary stop

Higher workpieces can be safely machined with the auxilia-
ry stop.
Push the auxiliary stop to the desired position and secure it
with the clamping lever (11B).
Make sure that the auxiliary stop is not in the cutting
plane! For inclined cuts and double mitre cuts, push it to
the left so that it is not touched by the saw blade.
16