Preparing For Commissioning - ATIKA KGSZ 250 N Notice Originale

Preparing for commissioning

To achieve flawless functioning of the machine, please
follow the instructions listed:
Place the machine at a location that meets the following
conditions:
− secured against slipping
− free of vibrations
− even
− free of tripping hazards
− adequate light
To ensure a safe position of the saw it must be bolted down
on a solid surface (e.g. workbench or support frame) at
optimal working height:
Mounting on a workbench / work table:
−
Place the device on a level flat workbench or work
table.
An uneven surface may result in saw blade jamming
or inaccurate cutting.
− Make 4 holes in the workbench / work table matching the
holes in the base plate (39).
− Bolt the device down.
Before each use, check
− Connection cables for defects (cracks, cuts, etc.)
Do not use any defective cables.
− the saw blade for flawless condition
Do not use deformed or damaged saw blades.
Immediately replace a worn or damaged table insert.
Connect the mitre crosscut saw to a dust collection device
when cutting wood.
Commissioning
Mains connection
Compare the voltage listed on the device type plate, e.g. 230 V,
with the mains voltage and connect the device to the
corresponding and proper socket.
Connect the machine via a 30 mA fault-current circuit breaker.
Use the connection or extension cable according to IEC 60245
(H 07 RN-F) with a core cross-profile section of at least
1.5 mm for cable lengths up to 25 m
2
2.5 mm for cable lengths over 25 m
2
Main fuse
10 A inert
On / Off Switch
Do not use any device where the switch can not be
switched on and off. Damaged switches must be repaired or
replaced immediately by the customer service.
Switch on
All manuals and user guides at all-guides.com
device from being inadvertently started. First press the locking
button (1C) and then the On/Off switch (1A). You can let go the
locking button while working.
Switching off
automatically returns to its home position and locks the On/Off
switch.
Switching on the laser
Removing the transport locking pin
Remove the transport locking pin before use:
Dust/chip exhaustion
Unless the machine is used outdoors, the dust bag (23) or a
chip exhaust system (e.g. portable dust remover) must be
connected.
Dust bag
• push the dust bag (23) onto the exhaust neck (24).
• regularly empty the dust bag.
Chip exhaustion
Attaching table extensions
19
The On/Off switch has a locking device to prevent the
Release the On/Off switch again. The locking button
Press the On/Off switch (1B).
Only switch on the laser when a work piece is on the rotary
table.
Slightly push the handle (1) down.
Pull out the transport locking pin (5).
The wood dust generated during operation impedes the
necessary view and is harmful to health to some degree.
When using the dust bag:
Connect a chip exhaust system or small vacuum cleaner
with suitable adapter to the chip exhaust neck (24) (dia. 47
mm).
Air velocity at the exhaust neck of the saw ≥ 20 m/sec.
Use a special exhaust device when exhausting dusts that
are especially harmful to health, carcinogen or dry.
Handling long work pieces with the help of the
supplied support arms.
The support arms can be mounted to the left and right of
the machine.
− Insert the support arms (18) into the respective holes
on the sides.
− Secure the support arms with the wing screws (19).
Safely support long work pieces with suitable means. For
example, use saw horses or similar devices to support
overhanging work pieces.