Technical Data - ATIKA KGSZ 250 N Notice Originale

Fault
Chip outlet is clogged
Rotary table moves hard

Technical data

Typ
Year of constructions
Motor input P
1
Mains voltage
Mains frequency
No-load speed
Saw blade diameter
Saw blade hole
min. tooth width
Number of teeth
Mitre left / right
Incline angle left
Max. cross-section of work piece (height x width)
Straight cuts:
Mitre cuts (rotary table 45°)
Inclined cuts (saw head 45° to the left)
Double mitre cuts (rotary table 45°/saw head 45°)
Exhaust connection
Dimensions (length x breadth x height)
Weight
Commercial small dust removers or industrial vacuum cleaners can be used for exhaustion.
Guarantee
Please observe the enclosed terms of guarantee.
All manuals and user guides at all-guides.com
Possible cause
• No exhaust system connected
• Exhaust power too weak
• Chips under rotary table
Removal
• Switch off saw, remove chips and connect
exhaust system
• Switch off saw, remove chips and increase
exhaust power (air velocity 20 m/sec at chip
exhaust neck.
• Remove chips
KGSZ 250 N
see last page
1800 W
230 V~
50 Hz
5000 min
–1
∅ 250 mm
∅ 30 mm
3.2 mm
36
0 – 45 °
0 – 45°
70 x 310 mm
70 x 205 mm
42 x 310 mm
42 x 205 mm
∅ 47
approx. 660 x 425 x 530 mm
approx. 10.7 kg
24