Possible Faults; Technical Data; Guarantee - ATIKA BWS 500 Notice Originale - Consignes De Sécurité - Pièces De Rechange

Possible faults

Before each fault elimination:
− Switch off device
− Wait unitl the saw comes to a stop.
−
Pull out power plug
After each fault clearance, put into operation and recheck all security installations.
Fault
Machine fails to start after switching on
Jigging does not work
Machine stops while cutting
Work piece jammed when pushing
forwards or backwards
Burned spots at the cut areas
Saw vibrates
Recuperating mechanism of the jigging
device does not work
Decelaration too slow (time to dead stop
>10 sec.)

Technical data

Type
Year of construction
Motor rating P
1
Motor output P
2
Mains voltage
Mains frequency
No-load speed n
0
Protection class
Mains fuse
Saw blade (carbide tipped saw blade)
Saw blade location hole ∅
Number of teeth
Thickness of splitting wedge
Cut width
max. cutting capacity
Wood length, max.
Wood length, min.
Dimensions (length x breadth x height)
Weight (incl. accessories)

Guarantee

Please observe the enclosed terms of guarantee.
Possible cause
• Power failure
• Extension cable defect
• Motor or switch defect
• Transport locking device not released
• Saw blade blunt
• Feed is too great
• Saw blade blunt
• Saw blade blunt
• Saw blade is warped
• Saw blade not properly mounted
• Recuperating spring broken or worn out
• Recuperating bolt popped out from its bracket
• Motor brake defective
• Brake disk worn
Remedy
• Check the fuse.
• Check cable, no longer use defect cable
• Have motor or switch checked by an approved
electrician or replaced by original spare parts
• Remove transport locking device (23)
• Replace saw blade (14)
• Allow motor to cool and proceed working with less
pressure
• Hold the work piece firmly and cut off the motor
immediately. Replace then the saw blade.
• Replace saw blade
• Replace saw blade
• Mount saw blade properly
• Replace the recuperating spring
• Insert the recuperating bolt in its bracket and secure it
with a cotter pin
• Have motor or switch checked by an approved
electrician or replaced by original spare parts
approx. ∅ min. 30 mm to max. 180 mm
BWS 500
see last page
3,0 KW S 6 – 40 %
2,2 KW S 6 – 40 %
230 V~
50 Hz
2990 min
–1
IP 54
16 A slow
min. ∅ 495 mm
max. ∅ 500 mm
30 mm
36
2,8 mm
3,8 mm
1000 mm
200 mm
875 x 980 x 920
56,5 kg
16