Storage; Guarantee; Possible Faults; Spare Parts - ATIKA DK 400 Notice Originale

Storage

Remove the mains plug from the socket.
+ Store unused equipment in a dry, locked place out of the
reach of children.
+ To extend the service life of the saw and guarantee smooth
operation, before storing for a longer period
− thoroughly clean the saw
− treat all movable parts with an environmentally friendly oil
Never use any grease!

Possible faults

Fault
After switching on, the
machine does not start or
switches off automatically.
Machine stops while cutting
Work piece jams when
pushing forward or pulling
back
Burn marks at the cut edges • Saw blade is unsuitable for the cutting
Chip exit blocked

Spare parts

Pos. Name
1 On / Off switch
17 Table insert
Possible cause
• Power failure
• Extension cable defect
• Motor or switch defect
• Saw blade blunt
• Saw blade blunt
task or blunt
• No exhaust suction connected
• Suction too weak
Spare parts no.
362890
362892

Guarantee

Please observe the enclosed terms of guarantee.
Removal (disconnect power plug)
• Replace fuse
• Check cable, no longer use defect cable
• Have motor or switch checked by an approved
electrician or replaced by original spare parts
• Replace saw blade
• Hold the workpiece firmly and switch the motor off
immediately. After this renew saw blade.
• Exchange saw blade
• Switch off saw and remove chips
Pos. Name
7 Saw blade protection
8 Saw blades
20
Spare parts no.
362891
362893 – 15 tpi
362887 – 18 tpi