Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Replacing the carbon brushes
Replace the carbon brushes if they are worn.
Place the machine on its side, remove the 6 screws
and the bottom cover.
Remove the carbon brush cover (29) on the side of the
motor cover by turning it counter clockwise using a suitable
screw driver.
Remove the carbon brushes; note the position of the spring
retention.
Insert the new carbon brushes (30) observing the correct
position of the spring retention.
Replace the carbon brushes only in pairs.
Screw in the carbon brush cover (29) again.
Remount the bottom cover and place the machine upright.
45° and 90° fine adjustment
In the event that the saw blade cannot reach the 45° and 90°
standard angles to the table plate, you can adjust the end stops
as follows:
Place the machine on its side and remove the bottom plate.
Loosen the locking nuts of the end stops and align the saw
blade at an angle of 90° and 45° to the saw table. Retighten
the locking nut.
Remount the bottom cover and place the machine upright.
Cleaning
Observe the following to maintain the functionality of the
saw.
Regularly clean the machine housing using a soft cloth or
brush, preferably after each use.
Keep the ventilation slits on the motor free from sticking
dust or dirt.
Do not wash down device with water.
Remove splints and sawdust only with a brush or vacuum
cleaner.
Clean and oil all moving parts regularly.
Never use any grease!
Use for instance sewing machine oil, liquid hydraulic
fluid or environmentally acceptable spray oil.
Take care that the saw blade remains free of rust and resin.
Remove all resin residues from the saw bench top
Fault
Machine fails to start after
switching on or switches off
during idle running
22
Possible cause
• Power failure
• Extension cable defect
• Motor or switch defect
• Saw blade sticks
• Carbon brushes worn after a longer period of
operation.
Resin residues can be removed with a commercial
maintenance and care spray.
T
r
T
Remove mains plug before each
transport.
Always transport the saw with the saw blade lowered.
This will avoid injury by the saw blade.
•
Always use the transport devices (e.g. table plate) for
handling or transporting the machine, never use any safety
devices (e.g. protective guard).
S
S
Remove the mains plug from the socket.
Store unused equipment in a dry, locked place out of the
reach of children.
To extend the service life of the saw and guarantee smooth
operation, before storing for a longer period
− thoroughly clean the saw
− treat all movable parts with an environmentally friendly
oil
Never use any grease!
G
G
Please observe the enclosed terms of guarantee.
P
o
s
P
o
s
Before each fault clearance
− switch off device
− wait for stop of chain saw
− pull out main plug
After each fault clearance, put into operation and recheck
all security installations.
Removal
• Replace fuse
• Check cable, no longer use defect cable
• Have motor or switch checked by an
approved electrician or replaced by original
spare parts
• Remove the cause of the jam.
• Replace the carbon brushes
a
n
s
p
o
r
t
r
a
n
s
p
o
r
t
t
o
r
a
g
e
t
o
r
a
g
e
u
a
r
a
n
t
e
e
u
a
r
a
n
t
e
e
s
i
b
l
e
f
a
u
l
t
s
s
i
b
l
e
f
a
u
l
t
s
Publicité
Chapitres
Table des Matières
