Cutting Wide Workpieces; Cross Cuts / Mitre Cuts; Maintenance And Cleaning; Maintenance - ATIKA PTK 250 S Notice Originale

Cutting wide workpieces

With the flat of the hand and the fingers closed, push the
work piece to be cut along the stop.

Cross cuts / mitre cuts

Slide the transverse stop (22) in the groove on the table and
adjust it to the desired angle.
Push the longitudinal stop (5) into the required position, so
that the work piece can be securely held in place.
Place the workpiece to be cut against the stop rails.
Hold the workpiece firmly in place and push it past the saw
blade using the transverse stop. Use the pushing bar if
necessary.
Adjust the stop ruler so that it reaches the saw blade.
M a i n t e n
M a i n t e n
Before each maintenance and cleaning
work
− switch off device
− wait for stop of chain saw
− pull out main plug
Malfunctions of the machine including defective guards or saw
blade must be reported to the person responsible for safety
immediately after detection.
Further maintenance and cleaning works than described in this
chapter shall only be carried out by the manufacturer or
companies named by the manufacturer.
For maintaining and cleaning, removed security devices must
unconditionally be mounted properly and proved again.
a n c e a n d C a r e
a n c e a n d C a r e
Use only original parts. Other parts can result in unexpected
damages and injuries.

Maintenance

Changing the saw blade
Before replacing the saw blade:
− switch off device
− wait for stop of chain saw
pull out main plug
−
The saw blade is a wearing part and will become dull after
prolonged or frequent use.
renew the saw blade or have it sharpened
Do not use any saw blades made of HSS steel.
Do not use any cracked saw blades or such that have
changed their shape.
Only use well-sharpened saw blades
The saw blade must comply with the specified requirements
under "Technical data".
Danger of cutting! Wear gloves when replacing the saw
blade.
Use only suitable saw blades.
Danger of burning! The saw blade is still hot shortly
after cutting.
Bring the saw blade to the highest position.
Remove the safety guard (1).
Screw off the 8 screws from the table insert and
remove the table insert.
Hold the saw blade flange (27) using the wrench (24)
and loose the hexagon screws (28) using the ring wrench
(25)
Wear safety gloves.
Remove the hexagon screws (28) and the saw blade
flange (27). Pull the saw blade (3) off.
Clean the saw blade receiver using a cloth or brush before
installing a new saw blade.
Clean the flanges.
Fit the new saw blade in reverse order.
Note the direction in which the saw blade turns (see arrow
on saw blade). The teeth of the saw blade must point towards
the front of the machine and the directions of the arrows on the
saw blade and on the guard must be identical.
Finally, fit the safety guard again.
Check the satisfactoy function of the exhaustion system on
a daily basis.
If the motor fails to come to a stop within 10 seconds,
replace the wearing parts of the motor brake. Only the
manufacturer may do this.
Replacing the table insert
Immediately replace a worn or damaged table insert.
21