Storage; Guarantee; Possible Faults - ATIKA KGS 210 N Notice Originale

Storage

Remove the mains plug from the socket.
Store unused equipment in a dry, locked place out of the reach of children.
Before extended storage, please observe the following to increase the service life of the device and to ensure smooth operation:
− thoroughly clean the saw
− treat all movable parts with an environmentally friendly oil
Never use any grease!

Guarantee

Please observe the enclosed terms of guarantee.

Possible faults

Before each fault clearance
− Switch off device
− Wait for standstill of the saw blade
− Pull out power plug
After each fault clearance, put into operation and recheck all security installations.
Fault
Machine fails to start after
switching on or switches off
during idle running
No crosscut function
Machine stops while cutting
Burned spots at the cut areas
Saw vibrates
Chip outlet is clogged
Rotary table moves hard
19
Possible cause
• Power failure
• Extension cable defect
• Motor or switch defect
• Transport locking pin not removed
• Saw blade is dull
• Feed is too great
• Saw blade is not suitable for the work step or is dull • Replace saw blade
• Saw blade is warped
• Saw blade not properly mounted
• No exhaust system connected
• Exhaust power too weak
• Chips under rotary table
Removal
• Check safety fuse
• Check cable, no longer use defect cable
• Have motor or switch checked by an ap-
proved electrician or replaced by original
spare parts
• Pull out transport locking pin (5)
• Replace saw blade (16)
• Allow motor to cool and proceed working
with less pressure
• Replace saw blade
• Mount saw blade properly
• Switch off saw, remove chips and connect
exhaust system
• Switch off saw, remove chips and in-
crease exhaust power (air velocity 20
m/sec at chip exhaust neck.
• Remove chips