Possible Faults; Technical Data - ATIKA KGSZ 210 Instructions D'utilisation

Possible faults

Before each fault clearance
− Switch off device
− Wait for standstill of the saw blade
− Pull out power plug
After each fault clearance, put into operation and recheck all security installations.
Fault
Machine fails to start after switch-
ing on or switches off during idle
running
Motor hums but does not start
No crosscut function
Saw blade jams while cutting
Burned spots at the cut areas
Saw vibrates
Chip outlet is clogged
Rotary table moves hard

Technical data

Typ
Motor output P
1
Mains voltage
Mains frequency
No-load speed
Mains fuse
Saw blade diameter
Saw blade hole
min. tooth width
Mitre left/right
Incline angle left
Max. cross-section of work piece (width x height)
Straight cuts:
Mitre cuts (rotary table 45°)
Inclined cuts (saw head 45° to the left)
Double mitre cuts (rotary table 45°/saw head 45°)
Exhaust connection
Dimensions (length x breadth x height)
Weight
Commercial small dust removers or industrial vacuum cleaners can be used for exhaustion.
Possible cause
• Power failure
• Extension cable defect
• Motor or switch defect
• Spindle lock engaged
• Transport locking pin not removed
• Locking device for pendulum cover not
opened
• Saw blade is dull
• Feed is too great
• Saw blade is not suitable for the work step or
is dull
• Saw blade is warped
• Saw blade not properly mounted
• No exhaust system connected
• Exhaust power too weak
• Chips under rotary table
Removal
• Check safety fuse
• Check cable, no longer use defect cable
• Have motor or switch checked by an ap-
proved electrician or replaced by original
spare parts
• Loosen saw blade locking device (24)
• Pull out transport locking pin (34)
• Open locking device (36)
• Replace saw blade (4)
• Allow motor to cool and proceed working with
less pressure
• Replace saw blade
• Replace saw blade
• Mount saw blade properly
• Switch off saw, remove chips and connect
exhaust system
• Switch off saw, remove chips and increase
exhaust power (air velocity 20 m/sec at chip
exhaust neck.
• Remove chips
KGSZ 210
1800 W (S3)
230 V~
50 Hz
4800 min
–1
10 A inert
∅ 210 mm
∅ 30 mm
2,5 mm
0-45 ° / 0-48°
0-45°
65 x 205 mm
65 x 145 mm
35 x 205 mm
35 x 145 mm
∅ 37
620 x 435 x 380 mm
14,5 kg
27