Possible faults
Fault
Machine fails to start after
switching on or switches off
during idle running
Machine stops while cutting
Workpiece
sticks
when
feeding
Burn marks at the cut edges • Saw blade is unsuitable for the cutting
Chip exit blocked
Possible cause
• Power failure
• Extension cable defect
• Motor protecting switch has tripped –
right LED on the control panel is flashing.
• Motor or switch defect
• Saw blade sticks
• Saw blade blunt
• Feed too large
• Saw blade blunt
• The longitudinal or parallel stop is not
parallel to the saw blade, see P. 14-15
task or blunt
• No exhaust suction connected
• Suction too weak
Removal
• Replace fuse
• Check cable, no longer use defect cable
• Switch motor back on after cooling
"Motor protection", P. 14
• Have motor or switch checked by an approved
electrician or replaced by original spare parts
• Remove the cause of the jam.
• Replace saw blade
• Allow the motor to cool off and then continue work
using less pressure
• Hold the workpiece firmly and switch the motor off
immediately. The have the saw blade sharpened or
renew
• Readjust the scale, see P.14-15
• Replace saw blade or have it sharpened
• Switch off saw and remove chips
• See "Safe working"
17