Device Description; Preparation For Commissioning - ATIKA DKV 400-2 Notice Originale

Device description / Spare parts
Pos Order-no Description
1
366215 Saw blade protection
2
366210 Workpiece hold-down device
3
366209 Sawdust blow-off device
4
366214 Table insert
5
Saw table
6
Stroke controller
7
ON-/OFF-switch
8
Extraction nozzle
9
Locking screw
10
Angle regulation (Angle scale)
11
366219 Saw blade box
12 Quick clamp
13 Attachment screw
14 Mounting
15 Saw blade mounting (up)
16 Saw blade mounting (down)
17 366220 Saw blade
17a Ersatz-Sägeblatt (o. Abbildung)
18 LED light
19 LED light ON/OFF switch
20 366221 Fuse holder
21 366217 Fuse (5A) ►
22 Safety label
Preparing for commissioning
To achieve perfect function of the machine, follow the

notes given in these instructions
You have to attach the following parts:
Sawdust blow-off device

Saw blade protection

Workpiece hold-down device

Assembly of the workpiece hold-down device
1. Insert the mounting (14) in the guide and fix it using the
attachment screw (13).
2. Screw the workpiece hold-down device (2) to the mounting
(14).
Assembly of the saw blade protection on the
sawdust blow-off device
1. Push the saw blade protection (1) on the mounting (14).
2. Push screw (M4x25) through the borehole of the
mounting and the saw blade protection and lock with the
screw nut (M4).
Assembly of the sawdust blow-off device
1. Screw the sawdust blow-off device (3) in the connector
(a).
Adjust saw table
Angle the saw table rectangularly
1. Move the workpiece hold-down device (2) to its top
position.
2. Use an angle to align the saw table (5) rectangular to the
saw blade (17).
3. If after adjusting the rectangularity the arrow (b) does no
longer show to 0°
 Release screw (c)
 Turn the arrow to the right or left (0°- Adjust position)
Refasten screw (c)

Assembly of the saw on a work bench
There are contained four rubber feet in the scope of delivery.
They are affixed down on the saw. Therefore, put the rubber
feet into the intended boreholes. Like this, the saw can be
assembled without additional safety.
But it can also be assembled fixed on a workbench to prevent
vibrations and noise when sawing. The small parts required for
►
the assembly are not contained in the scope of delivery. Use
therefore:
Description
Hexagon nut M 8
Gasket Ø 8mm
Washer Ø 8mm
Hexagon nut M 8, self-locking
Additionally we recommend a foam rubber base for the
reduction of vibrations and noise. It is not contained in the
scope of delivery.
 Place the saw in a place that fulfils the following conditions:
 secured against slipping
 free of vibrations
 even
 free of tripping hazards
 adequate light
 Before each use, check
 Connection cables for defects (cracks, cuts, etc.)
 that the saw blade protection is in a perfect condition
 that the saw blade is in a perfect condition
Do not use any cracked saw blades or those that have

changed their shape.
Do not use any defective cables
Quantity
4
4
4
4
19