Working Instructions; Maintenance And Care; Replacing The Fuse; Transport - ATIKA DKV 400-2 Notice Originale

Adjust stroke rate
To achieve always a satisfying cutting quality you can

regulate the stroke rate continuously.
Turn the stroke rate control (6)
To the right:
Number of revolutions
increases
To the left:
Number of revolutions
decreases

Working instructions

Before commencing work, ensure the following:
 Saw blade protection and saw blade o. k.?
 Saw blade sharp?
 Workplace tidied?
 You may not start to operate the machine until you have
read these operating instructions, observed all the
instructions given and installed the machine as described!
Also, note the following important points:
 Place yourself outside of the area of danger
 Take down the saw blade protection
- in case of breaks or when leaving the saw on the saw
table
- when working on the workpiece
 Lower the workpiece hold-down device (2) on the workpiece
as far as possible without clamping it.
 Place your hands flat on the workpiece with fingers closed.
With it, lead the work piece with the hand only up to the
leading edge of the saw blade protection.
 Never remove loose splinters, chips, or similar by hand.
Ensure that you always comply with the safety
instructions given on page 17 ff.

Maintenance and Care

Before each maintenance and cleaning
work:
- switch off device
- wait for the shutdown of the saw blade
- pull out main plug
Further maintenance and cleaning works than described in this
chapter shall only be carried out by the manufacturer or
companies named by the manufacturer.
For maintaining and cleaning, removed security devices must
unconditionally be mounted properly and proved again.
Use only original parts. Other parts can result in unexpected
damages and injuries.
Observe the following to maintain the functionality of the

saw.
 Use only a cloth, brush or vacuum cleaner for removing saw
chips and dust.
 Clean and oil all moving parts regularly.

Never use any grease!
Use for instance sewing machine oil, liquid

hydraulic fluid or environmentally acceptable spray
oil.
 Ensure that the saw blade remains free of rust and resin
 Remove all resin residues from the saw bench top
The saw blade is a wearing part and becomes blunt after
long or frequent use

renew then the saw blade

Replacing the fuse


This machine is equipped with a separate fuse.
1. Unscrew the fuse holder (20) and remove the fuse
(21).
2.
Carefully insert a new fuse (5A) and screw the fuse holder
back in again.

Transport

Remove the mains plug before each
transport.
Transport the saw only with hinged down protection cover.

This will avoid possible injury from the saw blade.
Remove the mains plug from the socket.
 Store unused equipment in a dry, locked place out of the
reach of children.
 To extend the service life of the saw and guarantee smooth
operation, before storing for a longer period
 thoroughly clean the saw
 treat all movable parts with an environmentally friendly
oil

Never use any grease!

Guarantee

Please observe the enclosed terms of guarantee.

Storage

21