Operation - Unold 78402 Notice D'utilisation

OPERATION

1. Ensure that the appliance is switched off via the ON/OFF switch.
2. Peel the desired ingredient (for some ingredients, such as zucchini, this is
not necessary) and cut off the ends with a knife.
3. Check whether the white drive wheel/the holder is seated in the appliance.
4. Now insert the desired cutting insert into the holder. Check whether the cut-
ting insert is straight in the holder.
Caution: Always touch the cutting inserts on the plastic
holder only, never touch the blades – danger of injury!
5. Fit on the filling shaft and turn it clockwise until it
engages. If the filling shaft is not mounted correctly the
appliance cannot be switched on!
6. Introduce the tamper with the food attached into the fill-
ing shaft and switch on the appliance via the ON/OFF
switch.
7. Press the tamper lightly downwards.
8. As soon as the ingredient is prepared, switch off the
appliance via the ON/OFF switch. Refill the tamper as needed and proceed
as described until your ingredients are used up. Please note that prior to
filling the appliance again, it must always be switched off.
9. Note: The brief operating time is 1 minute. Thereafter allow the appliance
to cool several minutes before processing more ingredients.
10. Unplug the mains plug when you are finished preparing the vegetables.
11. Carefully detach the filling shaft by turning it anti-clockwise and lifting it
down from the appliance.
12. To easily take out the cutting insert, from below, press it lightly upwards and
out of the holder.
The blades of the cutting inserts are very sharp – danger
of injury!
Stand 8.1.2020
Copyright UNOLD AG | www.unold.de
DE
EN
FR
NL
IT
ES
PL
27 von 86