Operation; Cleaning And Care - Unold 78525 Mode D'emploi

5. Turn the bowl counter-clockwise
in order to separate it from the
base.
6. Now you can take out the
batter and clean the appliance

OPERATION

1. Ensure that the appliance is not
plugged into the electrical outlet.
The speed switch must be on „0".
2. Check to make sure that the
appliance has been assembled
correctly.
3. Plug the power cord into an elec-
trical outlet.
4. Switch on the appliance. Always
begin with a low speed and then
slowly switch to a higher speed. In
doing so, you avoid spraying and
powder from the ingredients.
5. If too much dough sticks to the
edge of the bowl, switch the appli-
ance off in between and unplug
it from the electrical outlet. Take
the appliance apart and use a

CLEANING AND CARE

Before cleaning, switch off the
appliance and unplug it from
the electrical outlet.
1. You can wipe off the motor block
with a damp cloth and then dry it
thoroughly.
2. All removable accessories, such as
the mixing bowl, kneading hook,
etc. can be cleaned in warm water
Copyright UNOLD AG | www.unold.de
as described in the chapter
„Cleaning and care".
spatula to scrape the dough from
the edge of the bowl.
6. If you must add liquid to the
dough, open the fill opening, add
the liquid and then close the fill
opening.
7. When your dough is finished,
switch off the appliance by set-
ting the speed switch to „0" and
unplug the appliance from the
electrical outlet.
8. Process the dough as desired.
9. Note: The brief operating time is
6 minutes. After approx. 45 min-
utes of operation, allow the appli-
ance to cool before continuing, to
avoid overheating of the motor.
with mild dishwashing detergent;
then rinse with clean water and
dry thoroughly.
3. Attention, the mixing utensils are
not dishwasher-suitable!
4. The mixing bowl is dishwasher-
suitable and can be cleaned in
the top basket of the dishwasher.
29