Before Using The Appliance For The First Time; Operation - Unold 28310 Notice D'utilisation

3. For optimal coffee taste we
recommend grinding the coffee
beans right before use.
4. Use only fresh water.

BEFORE USING THE APPLIANCE FOR THE FIRST TIME

1. Remove all packaging materials.
Keep packaging materials away
from children - danger of suffo-
cation!
2. Rinse cup, lid, filter holder and
permanent filter in hot water with
a mild washing-up liquid, rinse
again with clean water and dry
thoroughly.

OPERATION

1. Ensure that the appliance is swit-
ched off.
2. Flip up the lid to fill the coffee
maker with water. Fill cold water
to the desired fill quantity into
the water fill tank (but do not fill
above the MAX mark). The quan-
tity of water you use depends on
your personal preference for cof-
fee flavour.
3. Turn the water nozzle to the rear
in order to first insert the filter
holder and then insert the per-
manent filter. Pay attention to the
apertures for filter holder and per-
manent filter to ensure the proper
seat of both parts.
4. Fill the desired amount of coffee
into the permanent filter, to taste,
per cup, 5-7 g (approx. 1 measu-
ring spoon) coffee powder ground
medium fine. Coffee that is
ground too fine can clog the pores
in the filter, which can cause the
Copyright UNOLD AG | www.unold.de
5. Coffee tastes best when it's freshly
brewed. If coffee is kept warm too
long, it can become bitter.
3. Wipe off the housing with a damp
cloth, and then dry it.
4. Before first use or if the appli-
ance has not been used for a lon-
ger period of time, fill the water
fill tank to the maximum quantity
with clean, cold water and exe-
cute three brewing cycles without
coffee powder.
coffeemaker to overflow. Do not
put too much coffee powder in
the filter; too much coffee powder
can cause the filter to overflow.
5. Important: Now turn the water
nozzle toward the front again until
it is directly above the permanent
filter.
6. Close the lid.
7. Check whether the placement
surface is fastened on the bottom
of the appliance (see illustration).
8. Place the cup without the cup lid
on the placement surface.
9. Plug the mains plug of the appli-
ance into an electrical outlet
(220–240 V~ 50 Hz).
10. Switch on coffee maker on the On/
Off switch (I/O). The red indicator
lamp lights up and the brewing
cycle starts.
11. After the brewing cycle ends, the
cup can be removed.
17