Publicité
TENS 13 program
TENS 13 is a program that you can also customise. In this program, you can set
the pulse frequency to between 1 and 150 Hz and the pulse width to between
80 and 250 µs.
1. Place the electrodes on your chosen area (for positioning suggestions, see
section "8.4 Information on electrode positioning") and connect them to the
device.
2. Select the TENS 13 program as described in section "8.2 Starting use" (step
3 to step 5).
3. Use the / setting buttons to select your preferred pulse frequency and
press the ENTER button to confirm.
4. Use the / setting buttons to select your preferred pulse width and press
the ENTER button to confirm.
5. Use the / setting buttons to select your preferred treatment time and press
the ENTER button to confirm your selection.
6. Use the left and right / setting buttons as needed for
select your preferred pulse intensity.
TENS 14 program
The TENS 14 program is a burst program that you can also customise. Various
pulse sequences run in this program. Burst programs are suitable for all areas
of application to be treated with changing signal patterns (to minimise the level
of becoming accustomed to the treatment). In this program you can set a pulse
width between 80 and 250 µs.
1. Place the electrodes on your chosen area (for positioning suggestions, see
section "8.4 Information on electrode positioning") and connect them to the
device.
2. Select the TENS 14 program as described in section "8.2 Starting use" (step 3
to step 5).
3. Use the / setting buttons to select your preferred pulse width and press
the ENTER button to confirm.
4. Use the / setting buttons to select your preferred treatment time and press
the ENTER button to confirm your selection.
5. Use the left and right / setting buttons as needed for
select your preferred pulse intensity.
and
and
© Copyright Gebrauchs.info
TENS 15 program
TENS 15 is a program that you can also customise. In this program, you can
set the pulse frequency to between 1 and 150 Hz. The pulse width changes
automatically during the stimulation treatment.
1. Place the electrodes on your chosen area (for positioning suggestions, see
section "8.4 Information on electrode positioning") and connect them to the
device.
2. Select the TENS 15 program as described in section "8.2 Starting use" (step
3 to step 5).
3. Use the / setting buttons to select your preferred pulse frequency and
press the ENTER button to confirm.
4. Use the / setting buttons to select your preferred treatment time and press
the ENTER button to confirm your selection.
5. Use the left and right / setting buttons as needed for
select your preferred pulse intensity.
to
EMS 33 program
EMS 33 is a program that you can also customise. In this program, you can set
the pulse frequency to between 1 and 150 Hz and the pulse width to between
80 and 320 µs.
1. Place the electrodes on your chosen area (for positioning suggestions, see
section "8.4 Information on electrode positioning") and connect them to the
device.
2. Select the EMS 33 program as described in section "8.2 Starting use" (step
3 to step 5).
3. Use the / setting buttons to select your preferred pulse frequency and
press the ENTER button to confirm.
4. Use the / setting buttons to select your preferred pulse width and press
the ENTER button to confirm.
5. Use the / setting buttons to select your preferred treatment time and press
the ENTER button to confirm your selection.
6. Use the left and right / setting buttons as needed for
select your preferred pulse intensity.
to
EMS 34 program
EMS 34 is a program that you can also customise. In this program, you can set
the pulse frequency to between 1 and 150 Hz and the pulse width to between
31
and
to
and
to
Publicité
