Télécharger Imprimer la page

Siemens SIMATIC NET SINEC OS V2.4 Manuel De Configuration page 497

Pour scalance xch-300, xcm-300, xrh-300 et xrm-300

Publicité

date
descriptor
11.3.3.5
Affichage du nom d'appareil PROFINET
Pour afficher le nom d'appareil PROFINET, exécutez la commande suivante en mode de
fonctionnement :
show running-config profinet name-of-station
Exemple
localhost# show running-config profinet name-of-station
profinet
name-of-station switch-vpm6002848
exit
Description
Les informations suivantes s'affichent :
name-of-station
11.4
EtherNet/IP
Ethernet Industrial Protocol (EtherNet/IP, EIP) est une norme industrielle ouverte pour Industrial
Ethernet temps réel, basée sur TCP/IP et UDP/IP.
Remarque
Le présent document ne fournit pas une description exhaustive du protocole EtherNet/IP. Pour
plus d'informations sur EtherNet/IP, voir le site Internet Open DeviceNet Vendor Association
(ODVA) (https://www.odva.org/).
Command Line Interface (CLI) SINEC OS V2.4
Manuel de configuration, 10/2023, C79000-G8977-C498-07
Paramètres
Paramètres
Description
Affiche la date d'installation ou de la première mise en service
de l'appareil.
Vous pouvez configurer la date avec SINEC PNI, p. ex.
Affiche des informations complémentaires sur l'appareil.
Vous pouvez configurer ces informations complémentaires
avec SINEC PNI, p. ex.
Description
Affiche le nom d'appareil PROFINET.
Configurez le nom d'appareil PROFINET avec SINIC PNI, par ex.
Si vous configurez le nom d'appareil PROFINET avec SINEC PNI
et qu'il ne correspond pas aux règles de la norme CEI
61158-6-10, il sera converti en conséquence. C'est le nom
converti qui est affiché.
Découverte et gestion de réseau
11.4 EtherNet/IP
497

Publicité

loading