Télécharger Imprimer la page

Siemens SIMATIC NET SINEC OS V2.4 Manuel De Configuration page 603

Pour scalance xch-300, xcm-300, xrh-300 et xrm-300

Publicité

13.3.2.3
Activation d'un serveur NTP
Un serveur NTP nouvellement configuré est par défaut automatiquement activé.
Pour activer un serveur NTP, procédez comme suit :
Opé‐
ration
1
2
3
4
5
Exemple
localhost# config
Entering configuration mode terminal
localhost(config)# system time-sync ntp unicast-configuration ipv4
192.168.16.100 enabled
localhost(config-ipv4-192.168.16.100)# commit
Commit complete.
localhost(config-ipv4-192.168.16.100)# end
localhost# show running-config system time-sync ntp unicast-
configuration ipv4 192.168.16.100 enabled
system
time-sync
ntp
exit
exit
exit
Command Line Interface (CLI) SINEC OS V2.4
Manuel de configuration, 10/2023, C79000-G8977-C498-07
Instruction
Passez en mode de configuration.
Activez le service NTP.
Validez la modification.
Quittez le mode de configuration.
Contrôlez la configuration.
unicast-configuration ipv4 192.168.16.100
enabled
exit
Réglages de la date/heure
Commande
config
system time-sync ntp unicast-
configuration ipv4 { Adresse IP }
enabled
commit
end
show running-config system time-
sync ntp unicast-configuration
ipv4 { Adresse IP } enabled
13.3 NTP
603

Publicité

loading