Publicité
Les langues disponibles
Les langues disponibles
Troubleshooting (DVD)
Problem
You cannot use the operation or function due to one of the following reasons:
icon appears on
(1) Your DVD disc does not support the feature (for example, angles)
the screen.
(2) You've requested a title, chapter, or scan time that is out of the correct range.
Play mode settings are
The disc does not support all the selected functions.
different from the set-
In this case, some settings you configure on the Setting menu may not work properly.
tings configured with
the Setting menu.
Cannot change the
Aspect ratio is fixed for DVD disc.
aspect ratio.
Check whether you selected correct digital output options in the Audio Output Options menu.
No audio output.
No video or audio output.
Did you move your DVD Recorder & VCR suddenly from a cold place to a warm place? In this
The disc tray is ejected
case, do not connect the plug to the power outlet and wait for two hours.
after 2 to 5 seconds.
Then insert the disc and try to play again.It will work properly when condensation has evaporated.
Angle operation does not
Angle operation is available only when the disc contains images captured at different angles.
work during playback of a
DVD disc.
• Check whether there is damage or foreign materials on your disc.
The disc revolves, but
• Some discs with bad manufacturing quality may not be played back.
no image or bad quali-
• If the scene changes from dark to bright suddenly, the screen
ty images are output.
Desired audio
Audio languages and subtitle languages are disc-specific.
language and
Only the sound and subtitle languages contained on a DVD disc are
subtitle language
available and displayed on the disc menu.
are not played.
No progressive
• Check whether PS
• Make sure to change the component video output using the Progressive button when
output.
• Point the remote control at the remote control sensor on your DVD Recorder & VCR.
The remote control
doesn't work.
• Check whether the batteries are depleted.
• Read the table of contents and then find and read the sections
Other problems
• Turn the unit off and on.
• If your problem still persists, contact your nearest Samsung service centre.
No HDMI output.
• Check the Video output is HDMI enabled.
• Check the connection between the TV and the HDMI jack of the DVD Recorder & VCR.
• See if your TV supports this 576p/720p/1080i DVD Recorder & VCR.
• If snow noise appears on the screen, it means that TV does not support HDCP (High-
Abnormal HDMI
output screen.
HDMI output Jitter
• Check your TV system setup correctly.
• Screen Jitter may occur when the frame rate is converted from 50Hz to 60Hz
• Please refer to the user's manual of your TV.
Explanation/Solution
may jitter temporarily, but it is not a defect.
is displayed on front panel.
the disc is stopped.
Operate within distance. (15ft)
Remove obstacles between your DVD Recorder & VCR and remote control.
describing your problem, and follow the directions given.
bandwidth Digital Content Protection).
for 720p/1080i HDMI (High Definition Multimedia Interface) Output.
English - 89
Publicité
