Publicité
Les langues disponibles
Les langues disponibles
Concerning Copy Control Signals
TV broadcasts that contain copy control signals may have
one of the following three signal types, Copy-Free, Copy-
Once and Copy-Never. If you want to record a copy-once
type programme, use DVD-RW with CPRM in VR Mode.
Copy-Free
DVD-RW(Ver.1.1)
O
DVD-RW(Ver.1.1)
with CPRM
VR mode
O
DVD-R
O
Once Copy Once has been recorded, additional record-
ing cannot be performed.
- Content Protection for Recordable Media (CPRM)
CPRM is a mechanism that ties a recording to the
media on which it is recorded. It is supported by some
DVD recorders, but not by many DVD players.
Each blank recordable DVD has a unique 64-bit media
ID etched in the BCA. When protected content is
recorded onto the disc, it can be encrypted with a 56-
bit C2 (Cryptomeria) cipher derived from the media ID.
During playback, the ID is read from the BCA and
used to generate a key to decrypt the contents of the
disc.
If the contents of the disc are copied to other media,
the ID will be absent or wrong and the data will not be
decryptable.
Recording the current
programme you are watching
1. Check the antenna cable is connected.
2. Check the remaining time on the disc.
DVD-RW discs should be formatted in advance before
beginning recording. Most new discs are sold unformat-
ted. Make sure to format your unformatted discs before
recording.
Press the OPEN/CLOSE button and place a recordable
1
disc on the disc tray.
Press the OPEN/CLOSE button to close the disc tray.
2
Wait until LOAD disappears from the front panel display.
Copy-Once
Copy-Never
-
-
O*
-
-
-
3
Press the PROG/TRK (
buttons to select the station you want to record.
4
Press the REC SPEED button repeatedly, to select the
recording speed (quality).
• XP (High, approx. 1 hour) ➝ SP (Standard,
approx. 2 hours) ➝ LP (Low, approx. 4 hours)
➝ EP (Extended Play, approx. 6hours/8hours)
VR
-RW
Available Time 00:28
5
Press the REC button.
6
Press the STOP button to stop or finish a record-
ing in progress.
• The message "Updating the disc information.
Please wait for a moment" is displayed.
Pausing / Resuming
• Press the REC PAUSE button to pause a recording
in progress.
• Press the REC PAUSE button again during pause to
resume recording.
• You can switch channels by pressing the
PROG/TRK (
/
) buttons while recording
pauses.
You can not change the recording mode and
s
the programme while recording.
Note
Recording will stop automatically if there is
s
no free space left for recording.
Up to 99 titles can be recorded onto a disc.
s
If the power interrupted due to power failure
s
or other reasons, the title being recorded will
not be saved onto the disc.
Recording will stop automatically if a copy
s
protected image is selected.
Do not use DVD-R authoring discs with this
s
unit.
/
) buttons or number
XP
PR 7
English - 59
Publicité
