Samsung DVD-VR330 Manuel D'instructions page 17

Connecting DVD Recorder &
VCR to the TV using the RF Cable
Make sure that both the television and the
DVD Recorder & VCR are switched off before
Note
connecting the cables.
Remove the aerial or network input cable from the
1
television.
Connect this cable to the 75Ω aerial jack marked
2
on the rear of your DVD Recorder & VCR.
3 Plug the RF Cable supplied into the
your DVD Recorder & VCR.
4 Plug the other end of the RF Cable into the con-
nector previously used for the aerial on the
television.
The RF cable connection of this product
sends only signals of TV.
Note
You must connect SCART cable or
Audio/Video cables to watch a DVD and
video tape from your DVD Recorder & VCR.
Connecting the SCART
Cable
❚
Case 1 : Connecting DVD Recorder & VCR
You can connect your DVD Recorder & VCR to the
television using the SCART cable if the appropriate input
is available on the television. You thus:
• Obtain better quality sound and pictures
• Simplify the setting up procedure of your DVD
Recorder & VCR
Regardless of the type of connection chosen,
jack on
you must always connect the RF Cable.
Note
Otherwise, no picture will be visible on the
screen when the DVD Recorder & VCR is
switched off.
Make sure that both the television and the
DVD Recorder & VCR are switched off before
connecting the cables.
1 Connect the Aerial Cable.
2 Connect one end of the SCART cable to the AV1
(TV) jack on the rear of the DVD Recorder & VCR.
3 Plug the other end into the appropriate connector
on the television.
to the TV using the SCART Cable
English - 17