Programming; Accessing The Menus - Honeywell 301 Serie Mode D'emploi

Programming

Accessing the Menus

The 301-ADI is equipped with a 2 x 8-character LCD display screen within its housing that allows you to config-
ure the settings for the 16 analog inputs and the 8 digital inputs. Use the keypad arrows (Up, Down, Esc, En-
ter) provided on the PCB to scroll through programming options.
When you open the 301-ADI housing (to access the display screen), the LCD screen displays only the product
name and the Modbus address. This is displayed whenever the screen is idle. The programming function is
password protected, you must log a password to access this function. The default password is VA.
Press Enter once to display the password screen.
•
When the password screen is first displayed, it shows AA as the password, with the cursor under the
•
first letter.
Use the Up or Down arrow buttons to change characters.
•
When the first letter is correct, press Enter to move to the second letter.
•
Press Enter once more to validate the password.
•
Once the password has been validated, the screen displays "*Menu* ConfigAI?", the first of three (3) main
menu options. Use the Up and Down buttons to scroll through the options and Enter to select the desired one:
Press the UP button once to move from the Config AI screen to the Config DI screen (press DOWN to
•
return to the previous screen)
Press the UP button again to move to the "Modbs ID" screen
•
Pressing ENTER at any screen opens a sub-menu that allows you to either enable or disable an input
•
or to change the Modbus address.
75
PASSWORD
AA
*MENU*
Cfg AI
*MENU*
Cfg DI
*MENU*
ModbsID