2. Groups Menu
Programming groups of transmitters allows several units to be combined which
then enables actions (events) to be taken based on a series of units rather than
each unit, individually.
MENU
1. TxInfo
3. Events
2. Groups
4. Acqui
3. Groups 001
<end> [...]
[...]
[...]
[...]
[...]
Empty all groups
A group is a stack containing the addresses from each of the transmitters included
in the group.
Groups are displayed in a single line; if a group contains more than four compo-
nents, the arrows must be used to scroll left and right of the display window to view
all members of a group.
The cursor in the Group screen is represented by the blinking brackets
(<end>). Any information between the brackets can be edited
Creating Groups
The 301C controller accepts a variety of transmitter models with a variety of gas
sensors. It can organize the data conveniently using groups and events. However,
the group logic requires that all the members of the group be from the same trans-
mitter models and the same sensor type. Mixing dissimilar sensors or transmitters
in a group can cause incorrect results.
•
Use the arrows to move the cursor to a group line and press Enter
•
The field can be edited when the brackets stop blinking and the word "end"
blinks
•
Use the up or down arrows to scroll through the list of all units connected to
the 301C controller, until the desired address is displayed.
•
Press Enter again to validate the address.
35
[...]
[...]