Erasing Unit Memory; 301C Programming; Fault Led - Honeywell 301 Serie Mode D'emploi

Erasing Unit Memory

This function enables the user to clear the unit's memory. This is useful if, for reasons unknown, the 301-AP
display panel experiences technical difficulties. Once the 301-AP memory is cleared, the 301-C controller re-
sets the AP memory and the display should return to normal.
1. Press an arrow to scroll to the Menu ClearMem option, press the Enter pushbutton to select.
2. The screen displays ClearMem All Adr. Press the Enter pushbutton to select the option or use the ar-
rows to select the address to delete.
3. Press an arrow pushbutton to scroll to Yes or No and press Enter to confirm. The display returns to the
Menu Set ADR. screen.
4. Press an arrow to scroll to the next desired option or to the QUIT screen and press Enter to confirm the
selection or exit the programming menus.
Exiting the Programming Menu
Follow the steps below to exit the programming menu.
Press an arrow to scroll to the QUIT screen and press Enter to exit the programming menus.

301C Programming

Under the 301C Config Menu, change AP Broadcast (AP Brdcst) from Auto to Act.
The LCD displays * WAIT * Re-init as the transmitter implements all the changes that were made in the user's
menu before returning to normal operation.

Fault LED

If the transmitter experiences any communication difficulties, the fault LED will automatically turn on. The fault
LED will also light when a fault occurs on the301-C or AA96D controller. If the system is in fault mode, contact
Honeywell.
In the event of a fault, the LCD will display the following messages:
WAIT
MASTER
67
NO ERR
MEM
MASTER