Setting The Address - Honeywell 301 Serie Mode D'emploi

Setting the Address

Each unit is configured with a default address. However, if the unit is part of a network of devices, each should
have a different address.
Follow these steps to set the address:
1. When the screen is displaying, the Menu Set ADR. option (immediately after password login), press
the Enter pushbutton to select the option.
2. Press an arrow pushbutton to scroll through the different addresses (001 to 254).
When the desired address is displayed, press Enter to set the new address. The
display returns to the Menu Set ADR. screen.
3. Press an arrow to scroll to the next desired option or to the QUIT screen and press
Enter to confirm the selection or exit the programming menus.
If the 301-AP is to be compatible with the 301-C and
AA96D controllers, the address must be between 1
and 96.
Changing Relay Settings
Although the unit is ready to use, with default relay settings, this option allows users to modify relay failsafe
settings.
The process to change the settings for each relay is identical:
1. Press an arrow to scroll to the SetRelay menu option and press Enter to select.
2. SetRelay Rel #1 appears on the screen. Press an arrow to scroll to the desired relay number and press
Enter to select.
The screen now shows the current failsafe setting. Use the arrows to scroll to the desired setting (Yes
to activate the failsafe, No to deactivate) and press Enter to confirm the new setting.
3. Once the new value is accepted, the unit returns to the SetRelay Rel #1 screen.
65
Menu
SetRelay
SetRelay
Rel #1
FailSafe
R1 = No?
Menu
Set ADR.
Set ADR.
ADR: 003