Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Relay Outputs
The relays outputs will withstand up to 5 amps at 30 Vdc or 250 Vac (resistive load only). They can be used to
activate horns, strobes, etc. Refer to drawing below for proper wiring.
See APPENDIX section in the 301EM User's Manual for more details about B-52 and ASHRAE standard con-
figuration.
Risk of electrical shock - disconnect all power (input
and relay) before servicing.
Calibration/Programming
User interface
When power is initially applied, the unit's LCD screen will display the product's name and firmware revision.
Programming
The unit performs the programmed actions depending on what accessories are connected to the unit. The
301EMRP addresses must be programmed on each unit to enable them to receive information from the
301EM. Once the addresses are programmed, the 301EM will detect the remote panels through network
scans.
99
Publicité
Table des Matières
