Receiving And Unpacking; General Specifications; General Information For All Models - Honeywell 301 Serie Mode D'emploi

Receiving and Unpacking

Upon receiving the controller units:
Check that the package is undamaged
•
Carefully open the package
•
Locate the packing slip or purchase order and verify that all items on the or-
•
der are present and undamaged
Locate Quick Start Guide—read and understand the content
•
If the package or any of its contents are damaged,
please refer to the Warranty section at the back of
the manual for instructions.

General Specifications

General Information for All Models

Voltage: 24 ± 10% Vac, 50/60 HZ, 24 ± 10% Vdc
Voltage (S301-IRF and S301-D2): 12Vdc
Certifications: USA: Safety Requirements for Electrical Equipment for Measure-
ment, Control, and Laboratory Use - Part 1: General Requirements [UL 61010-
1:2012 Ed.3+R:29Apr2016]
Canada: Safety Requirements for Electrical Equipment for Measurement, Control,
and Laboratory Use – Part 1: General Requirements (R2017) [CSA C22.2#61010-
1-12:2012 Ed.3+U1;U2]
Products with C24 suffix - Comply with California Title 24, Part 6 and associated
Administrative Regulations in Part 1
Operating environment: Indoor Use, Ordinary Location 0 - 95% RH, non-con-
densing Up to 3000 m (9843 ft.) altitude (see specific system monitor types for sen-
sor limitations)
Specification Summary: A table of technical specifications for all models can be
found in Appendix E.
System design should be carefully considered prior to beginning to install. All com-
ponents as designed to be wired together as shown in the Wiring Diagram (Page 13).
Guidelines for the required number and height on monitors is provided (page 14).
8